OWC Mercury Elite Pro Dual Guide de l'utilisateur télécharger pdf (Page 9)

OWC MERCURY ELITE PRO DUAL

SYSTEM SETUP

6. Using eight of the larger screws from the packet you removed from the inner chassis,

fasten the hard drives into the inner chassis. There are four screw holes on each side of the

inner chassis, as circled below in red.

7. Note that while the inner chassis can slide into both sides of the outer enclosure, there is

only one correct way that will allow the screw holes to line up correctly. To determine the

correct orientation of the outer enclosure with the inner chassis, turn the outer enclosure

on its side and look at the bottom. As shown below, the screw holes at the front of the

outer enclosure are close to the silicone feet. The screw holes at the rear of the outer

enclosure are farther away from the silicone feet.

REAR FRONT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

OWC Mercury Elite Pro Dual Guide de l'utilisateur Page 9