OWC Mercury On-The-Go Spécifications télécharger pdf (Page 8)

OWC Mercury On-The-Go Pro Chapter 2 - System Setup

2 SYSTEM SETUP

2.1 Hard Drive Assembly & Installation (continued)

Slide the bridge card with the hard drive into the aluminum heatsink -

there is a notch that the bridge card will slide into.

Secure the hard drive using 4 screws from the included plastic bag,

through the heatsink, into the hard drive. Don’t overtighten, start all 4

screws before fully tightening.

Gently slide the completed heatsink, drive, and bridge assembly into

the acrylic enclosure. Take 4 Phillips screws from the included plastic

bag and once again, don’t fully tighten the screws, just start them,

as you will need to rock the assembly back and forth a bit to get all 4

screws started, then you can tighten them. Note that there is a rubber

mounting strip on the bottom of the heatsink, that makes it a bit di-

cult to get the screws all the way in. You may nd holding the enclosure

in your hand, screws down, works best.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

OWC Mercury On-The-Go Spécifications Page 8