OWC OWCDIDIMM11D2 Manuel d'installation télécharger pdf (Page 8)

2 Disassembly

Disconnect the IR board cable by lifting up on the connector body from

behind using the green pry tool. Be extremely careful as VST connectors

are very fragile. Do not get UNDER the connector on the logic board,

you want to lift the body of the connector itself. Lift on the body only,

do not pull on the wires. NOTE: The 2012 Mac mini has less clearance

between the hard drive and the logic board. You may need to wiggle

the drive a bit to get under the connector, use extreme care! This is

easily damaged and not repairable, but must be replaced if broken.

Look at the logic board opposite the hard drive. You will see 2 holes on

the logic board that are used to facilitate removal of the logic board.

⑱

⑲

Mac mini 2011-2012 2nd Hard Drive Kit

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

OWC OWCDIDIMM11D2 Manuel d'installation Page 8